Files
solidcraft/tests/kernel-cases/threads/995-m5-thread-in-5mm-hole/expected.json
T
Brennen HerbruckandClaude Opus 5.5 5dd3acdec0 kernel-cases: on the kernel branch a thread off its hole or shaft size is refused
The kernel runs exact helical sweeps and never resizes; the check that
refuses a thread off its hole's or shaft's size is the engine's sugar
(AGENTS.md). So the seven cases (995, 1443, 2152, 2969, 3366, 2369,
2705) go back to expecting that refusal and its message, as 1375e905 had
them, reversing 1588dd70.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 02:28:47 -04:00

13 lines
1.2 KiB
JSON

{
"sources": [
"tangency-labs/solidcraft#995",
"tangency-labs/solidcraft#1018",
"tangency-labs/solidcraft#2853"
],
"what": "a modelled thread on a hole that isn't the thread's size: refused with the size to use, never a silent change of the hole",
"source": "analytic",
"method": "Decision (#1018, #2853): a modelled thread never changes the size of the hole it is on; one that isn't the thread's size is refused, naming the size to use. A fill-to-tap-drill or turn-down option would be opt-in, off by default (see #3060), and get its own case. The refusal's numbers, from ISO 68-1 (H = P sqrt3/2, basic depth 5H/8): M5 (P 0.8): tap drill = 5 - 0.8 = 4.2 mm; basic depth 5H/8 = 5/8 x 0.8 x sqrt3/2 = 0.433 mm; a 5 mm hole is at the major diameter, so the internal thread (major d, minor d - 2 x 5H/8) cuts 0.00 mm. Expected message: \"this 5 mm hole is too wide for a modelled M5 thread: it would cut 0.00 mm of the thread's 0.43 mm depth; drill 4.2 mm for M5, or thread this hole M6\".",
"outcome": "refused",
"refusal": "this 5 mm hole is too wide for a modelled M5 thread: it would cut 0.00 mm of the thread's 0.43 mm depth; drill 4.2 mm for M5, or thread this hole M6"
}