The kernel runs exact helical sweeps and never resizes; the check that refuses a thread off its hole's or shaft's size is the engine's sugar (AGENTS.md). So the seven cases (995, 1443, 2152, 2969, 3366, 2369, 2705) go back to expecting that refusal and its message, as1375e905had them, reversing1588dd70. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
13 lines
1.2 KiB
JSON
13 lines
1.2 KiB
JSON
{
|
|
"sources": [
|
|
"tangency-labs/solidcraft#995",
|
|
"tangency-labs/solidcraft#1018",
|
|
"tangency-labs/solidcraft#2853"
|
|
],
|
|
"what": "a modelled thread on a hole that isn't the thread's size: refused with the size to use, never a silent change of the hole",
|
|
"source": "analytic",
|
|
"method": "Decision (#1018, #2853): a modelled thread never changes the size of the hole it is on; one that isn't the thread's size is refused, naming the size to use. A fill-to-tap-drill or turn-down option would be opt-in, off by default (see #3060), and get its own case. The refusal's numbers, from ISO 68-1 (H = P sqrt3/2, basic depth 5H/8): M5 (P 0.8): tap drill = 5 - 0.8 = 4.2 mm; basic depth 5H/8 = 5/8 x 0.8 x sqrt3/2 = 0.433 mm; a 5 mm hole is at the major diameter, so the internal thread (major d, minor d - 2 x 5H/8) cuts 0.00 mm. Expected message: \"this 5 mm hole is too wide for a modelled M5 thread: it would cut 0.00 mm of the thread's 0.43 mm depth; drill 4.2 mm for M5, or thread this hole M6\".",
|
|
"outcome": "refused",
|
|
"refusal": "this 5 mm hole is too wide for a modelled M5 thread: it would cut 0.00 mm of the thread's 0.43 mm depth; drill 4.2 mm for M5, or thread this hole M6"
|
|
}
|