The kernel runs exact helical sweeps and never resizes; the check that refuses a thread off its hole's or shaft's size is the engine's sugar (AGENTS.md). So the seven cases (995, 1443, 2152, 2969, 3366, 2369, 2705) go back to expecting that refusal and its message, as1375e905had them, reversing1588dd70. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
13 lines
1.1 KiB
JSON
13 lines
1.1 KiB
JSON
{
|
|
"sources": [
|
|
"tangency-labs/solidcraft#2152",
|
|
"tangency-labs/solidcraft#1018",
|
|
"tangency-labs/solidcraft#2853"
|
|
],
|
|
"what": "a modelled thread on a hole that isn't the thread's size: refused with the size to use, never a silent change of the hole",
|
|
"source": "analytic",
|
|
"method": "Decision (#1018, #2853): a modelled thread never changes the size of the hole it is on; one that isn't the thread's size is refused, naming the size to use. A fill-to-tap-drill or turn-down option would be opt-in, off by default (see #3060), and get its own case. The refusal's numbers, from ISO 68-1 (H = P sqrt3/2, basic depth 5H/8): M3x0.2: tap drill = 3 - 0.2 = 2.8 mm; depth 5H/8 = 5/8 x 0.2 x sqrt3/2 = 0.108 mm; the 3 mm hole is at the major diameter. Expected message: \"this 3 mm hole is too wide for a modelled M3x0.2 thread: it would cut 0.00 mm of the thread's 0.11 mm depth; drill 2.8 mm for M3x0.2, or thread this hole M4\".",
|
|
"outcome": "refused",
|
|
"refusal": "this 3 mm hole is too wide for a modelled M3x0.2 thread: it would cut 0.00 mm of the thread's 0.11 mm depth; drill 2.8 mm for M3x0.2, or thread this hole M4"
|
|
}
|