Files
solidcraft/tests/kernel-cases/ladder/09-shells-and-offsets/011-part-shell/expected.json
T
jyvikoandClaude Opus 5.5 c9dcc42a13 kernel-ladder: tier 09 shells grade their geometry
010, 011 and 014 passed on one valid body alone. 010 (top rounds in
mitres, shelled open below) and 014 (drafted box with tilted rounds:
every level section loses the same elliptic corner) now check closed-form
volumes, exact counts and bbox (014 also its centre of mass). 011, the
running part shelled 1.5, checks the part less its cavity built feature
by feature, the offset faces meeting sharp at concave edges as in the
rest of the tier (a distance-based offset would differ by 0.3%). All hold
on SMLib (worst 1e-6 relative).

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 02:28:53 -04:00

24 lines
1.3 KiB
JSON

{
"sources": [],
"what": "the running part shelled 1.5 mm open at the bottom",
"source": "analytic",
"method": "V = the tier-08 part - its cavity, the part's inside at 1.5 from every face but the open bottom, the offset faces extended to meet at the part's concave edges (as every shell in this tier: sharp inner corners). Cavity: the L section (x 1.5..58.5; y 1.5..38.5 under z 18.5, y 31.5..38.5 under z 33.5) less the r5 -> r3.5 front rounds, the wall's r3 -> r1.5 round and its 2 mm chamfer -> a (1.5 sqrt2 - 1) chamfer; the boss column r6.5 z 18.5..28.5 with its 1 mm chamfer -> 0.121, the concave r1 -> r2.5 at its root (Pappus), less the M5 hole grown 1.5 (r3.6, its floor's edge kept sharp); less the slot grown to width 11, the M6 tap drill to r4, the d3.3 hole to r3.15 (its overlaps with the wall's inner round and chamfer, 0.6808 and 0.4392, added back), the window grown 1.5 through the wall's 7 mm inside (Steiner, A + L t + pi t^2, its two corners sharp: + 2 t^2 (tan(th/2) - th/2)), and its overlap with the inner round (0.0416) added back = 37609.223572. A distance-based offset (concave edges rounded r1.5) would leave a cavity 49.17 larger. Bbox: the part's",
"body_count": 1,
"volume_mm3": 15397.712974981,
"bbox": {
"min": [
0,
0,
0
],
"max": [
60,
40,
35
]
},
"tolerance": {
"rel": 0.0001
}
}