An M8 modelled thread in a 6 mm hole, narrower than M8's minor diameter, was refused as "the face is too far from the thread's diameter". It now says what is wrong and what fits, as a hole that is too wide already does (#995): "this 6 mm hole is too narrow for a modelled M8 thread (its teeth would fill the hole); drill 6.75 mm for M8", with the thread that fits this hole when there is one. A shaft too thick for its thread gets "make the shaft 8 mm for M8". Fixes #2688 Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com> Co-authored-by: bherbruck <brennen.herbruck@gmail.com>