Files
solidcraft/crates/doc/src
jyvikoandClaude Opus 5.5 918429c6dc Sheet machining: a trimmed To Object tool is measured as the prism its record proves
A To Object extrude to a curved face runs its tool through the target and
cuts the target out of it. The SMLib boolean carries no extrusion face
sources (they stood for the untrimmed profile), so sheet_tool_span, which
read the tool's depth and footprint only off its extrusion caps, gave up
and the intersect was refused as unrepresentable.

The tool's current geometry says what it is: the kernel's prism
certificate (prism_measure, the one component copies are compared by)
reads off the exact record whether a body is a uniform prism along a
direction, its two cap levels and its section of lines and arcs. It is
now public as certified_prism_section, and sheet_tool_span uses it when
the caps don't certify the tool: the levels are the depth, the section the
footprint the To Object cut is bounded by. A tool trimmed to something
that is not a prism (a curved roof over it) is still refused.

partial_depth_intersect_curved_to_object_preserves_current_trimmed_cap_footprint
passes: the tool is the square 20 ... 30 less the pin's circle (radius 2),
z 0 ... 1, 100 - 4π, as the test's own witness extrude measures it. A
kernel test reads that section off the trimmed lump.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-30 05:55:40 -04:00
..
2026-10-24 18:53:40 -04:00