Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 fe7b37720b kernel: extrude, revolve, sweep, loft and coil through SMLib behind SOLIDCRAFT_KERNEL
With SOLIDCRAFT_KERNEL=smlib, extrude (and extrude_whole_sides, so boxes and cylinders too),
revolve and revolve_whole, extrude_tapered(_between), sweep and sweep_with, loft,
loft_with_rails, loft_regions and sweep_helix (coils, and the threads' grooves) build their
bodies with the fork's sweeps (smlib_sweeps.rs): the profile's segments go to SMLib as curves
(lines, arcs, Béziers and conics as NURBS), the result comes back through its schema 4 record,
and one SMLib's own check refuses is an error. What SMLib has no sweep for answers "not
supported yet", never truck's sweep: twists, end scales, guide rails and orientation
directions; paths with corners and paths of points; lofts with holes or to a point; draft
extrusions of profiles with holes or with a straight foot.

History is in the builders' vocabulary, found from the result's geometry as provenance.rs does
for operations without exact history: a wall comes from the segments its start edge runs along
(and, for extrusions and revolutions, whose middles it holds half-way), the face in the start
plane where the profile bounds it is the start cap, the one at the end the end cap. Straight
extrusions also carry their faces' construction sources (ExtrudeCap, ExtrudeSide), which the
box and cylinder certificates need. The loft's section matching is truck's own, now
loft_numbered_loops (split out of loft_numbered_wires, unchanged), so both kernels pair the
same vertices.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01QWhMwdqJYQKQq8RCLSL1LT
2026-10-27 02:28:47 -04:00
..