Files
solidcraft/crates/doc
FrankandClaude Opus 5.5 7239c95858 Sketch Project: round edges project as arcs, not short lines (#10312)
Projecting a whole body fitted its outline from mesh edges: a round wall seen
edge-on has triangles leaning a hair either way, so the outline zig-zagged
between both rims and broke into two-point pieces (lines), and seams where two
faces' triangles don't share vertices counted as open, outline edges. Faces
that face one way all over (planes, cylinders and cones about the sketch
normal) now decide for all their triangles, near vertices are welded, and a
seam between two faces facing the sketch is no outline. A STEP hook went from
159 lines to 10 lines and arcs.

A single rounded or chamfered rim of a cut curved face is a spline that only
follows its circle; read as Bezier pieces it came in as twenty splines. An
edge read as spline pieces that stays on a circle within 1e-5 of its radius,
in a plane parallel to the sketch, now comes in as that arc.

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-01 07:13:00 +00:00
..