Files
solidcraft/tests/kernel-cases/fillets/KNOWN_FAILING
T
jyvikoandClaude Opus 5.5 242bbc89f0 Fillet rig: the known-failing list follows the SMLib 7e917f0 pin
Ten cases the pin fixed leave the list (the 1207 corner patch and its together cases, 1390,
4782 reduce-fit, 896). 1557 joins it with its cause: since bodies are read back from their
records (#8625) its bottom rounds come back as SmCylinder where SMLib's blend made SmCone(0),
and the corner-ball trace starts 2.78e-4 off; its fix is in progress.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-29 07:14:45 -04:00

14 lines
1.6 KiB
Plaintext

# The fillet cases that fail today, one a line: `<case> <why it fails today>`. Sorted. The fillet
# rig gate (.github/workflows/fillet-rig.yml) fails on a case that fails and is not listed here,
# and on a listed case that passes: a fix removes its line in the same pull request.
# Baseline: develop 229739a70 (SMLib 7e917f0), aarch64 Linux, 2026-10-29.
1207-fillet-bar-top-edge-after-boss-arc-round-r0-5 SMLib's check refuses the round: internal coincident control points in a B-spline curve (an internal pole)
1557-fillet-vertical-corners-after-bottom-rounds SMLib status 1001 since bodies are read back from their records (#8625): the bottom rounds come back as SmCylinder where SMLib's blend made SmCone(0), and the corner-ball trace starts 2.78e-4 off
4782-fillet-bar-edge-wider-than-both-faces SMLib status 1001: a convex round past both its faces is not yet built by subtraction
4782-fillet-two-end-verticals-past-a-full-round SMLib's result is not a closed solid, where a refusal naming 7.5 mm (fillet_max for the exact fit) is right
5158-fillet-round-just-past-a-10mm-face SMLib status 1001: a convex round 0.01 past its face is not yet built by subtraction (10.0001-10.04 open)
9-fillet-corner-curvature-with-reduce-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
9-fillet-corner-curvature-with-taper-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
9-fillet-corner-r1-curvature-default-setback continuity g1: the g2 corner patch seams G1 at the corner point, not G2
9-fillet-corner-r5-curvature-default-setback continuity g1: the g2 corner patch seams G1 at the corner point, not G2