Files
solidcraft/tests/kernel-cases/threads/2369-m8-thread-in-6.3mm-hole-refused/expected.json
T
Brennen HerbruckandClaude Opus 5.5 5dd3acdec0 kernel-cases: on the kernel branch a thread off its hole or shaft size is refused
The kernel runs exact helical sweeps and never resizes; the check that
refuses a thread off its hole's or shaft's size is the engine's sugar
(AGENTS.md). So the seven cases (995, 1443, 2152, 2969, 3366, 2369,
2705) go back to expecting that refusal and its message, as 1375e905 had
them, reversing 1588dd70.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 02:28:47 -04:00

14 lines
1.1 KiB
JSON

{
"sources": [
"tangency-labs/solidcraft#2369",
"tangency-labs/solidcraft#2688",
"tangency-labs/solidcraft#2853",
"tangency-labs/solidcraft#1018"
],
"what": "a modelled thread on a hole that isn't the thread's size: refused with the size to use, never a silent change of the hole",
"source": "analytic",
"method": "Decision (#1018, #2853): a modelled thread never changes the size of the hole it is on; one that isn't the thread's size is refused, naming the size to use. A fill-to-tap-drill or turn-down option would be opt-in, off by default (see #3060), and get its own case. The refusal's numbers, from ISO 68-1 (H = P sqrt3/2, basic depth 5H/8): M8 (P 1.25): tap drill = 8 - 1.25 = 6.75 mm; basic minor diameter D1 = 8 - 2 x 5H/8 = 8 - 1.353 = 6.647 mm; a 6.3 mm hole is below the minor diameter, so the thread's teeth would fill part of the hole. Expected message: \"this 6.3 mm hole is too narrow for a modelled M8 thread (its teeth would fill the hole); drill 6.75 mm for M8\".",
"outcome": "refused",
"refusal": "this 6.3 mm hole is too narrow for a modelled M8 thread (its teeth would fill the hole); drill 6.75 mm for M8"
}