Files
solidcraft/tests/kernel-cases/ladder/07-fillets/013-corner-setback/expected.json
T
jyvikoandClaude Opus 5.5 f6b42d4162 kernel-ladder: 07/016 is a refusal; 07/018 the same corner with r2; cases.py makes 013
The r7 on the vertical edge runs on (tangent chain) up the side's arc on the
r5 round, a circle of radius 5: its contact line on that face would be the arc
offset 7 towards its centre, so no such round exists and the right answer is
a clean refusal. 018 picks a radius that fits (r2: 11 faces, inside the box).
cases.py now writes 013 (the corner setback, graded by its convexity bounds)
instead of marking it missing; its tolerance is the interval's exact half
width.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 02:28:53 -04:00

27 lines
1.4 KiB
JSON

{
"sources": [],
"what": "three r5 rounds at the corner (60,40,20) with setbacks of 8 mm along each edge",
"source": "invariants",
"method": "outside the corner cube C = [52,60]x[32,40]x[12,20] the body is the sphere corner's (009: V0 = 47377.120025868, of which 512 - 225 (1-pi/4) - 125 (1-pi/6) lies in C); the body is convex, so in C it holds the hull of its points on C's faces (the rounds' sections at the setback planes x=52, y=32, z=12 and the cube's corners outside the patch: 299.0201 by a hull of the sections sampled, below the true hull) and lies within the planes tangent to it along those sections, the three rounds' prisms (512 - 225 (1-pi/4) - 125 (sqrt2-1): the corner cube of r keeps the cylinders' common octant (2-sqrt2) r^3). The volume is the middle of [47271.9757, 47384.8935] with that half width as its tolerance. The box is unchanged. SMLib's setback patch is two quadrilaterals per side meeting at its centre: 6 box faces, 3 rounds, 6 patch pieces; vertices: 4 untouched box corners, 2 at each round's far end, the 6 section ends (where the patch starts, 8 from the vertex along each edge), the 6 side middles and the centre (23); edges by Euler, 23 + 15 - 2",
"body_count": 1,
"volume_mm3": 47328.434587888,
"faces": 15,
"edges": 36,
"vertices": 23,
"bbox": {
"min": [
0,
0,
0
],
"max": [
60,
40,
20
]
},
"tolerance": {
"rel": 0.00119391703234033
}
}