Convert to Sheet Metal refused a tray made with SolidCraft's own sheet metal, exported and
imported again: its walls run on past each bend's end (notch, tear and round corner reliefs), so
the edges beside the bend cylinder's edge never reach the other face's plane and the face could
not be trimmed ("a face beside a chamfer picked as a bend does not reach the face across it").
Where that edge is round or runs on along the bend's line, the face now keeps its corner and
steps down square to the other plane, a step the bend's setback takes up again; the inset drops
an edge the setback leaves shorter than the tolerance.
Test: trays_of_its_own_sheet_metal_convert_back (notch, tear and round, the walls made in one
flange feature, and notch and round with the short walls in a second one): the volume, the flat's
size and outline area and every bend's length are the source's.
Fixes#7529.
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>