Files
solidcraft/crates/engine
semmelrindeandClaude Opus 5.5 e2c9f908f8 Sketch: an offset slot can still be moved by the dimension that places it (#6569) (#6697)
* claim: #6569

* Sketch: an offset slot can still be moved by the dimension that places it (#6569)

An offset arc is drawn round its source's own centre, and its ends are
held while the sketch solves (the offset is rebuilt from its source
afterwards). Its arc condition, both ends as far from the centre, then
only tied that shared centre, and the source arc with it, to the middle
of the held ends: a slot offset by 1 mm lost a degree of freedom, and
the length that places it was refused as conflicting.

The solver and the constructive reading now leave out the arc condition
of an offset arc round its source's centre (Sketch::offset_arc_follows_source),
as #4466 did for the Parallel between an offset line and its source. The
source's own arc keeps the centre; nothing changes without an offset.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch: a test for a rounded rectangle with an offset round it (#6569)

kaievns's case from the review: the offset's corner arcs tied each corner
centre to a 45 degree line, so the height followed the width and every
width change was refused.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-26 11:12:15 +00:00
..