Files
solidcraft/crates
jyvikoandClaude Opus 5.5 dc3d504bae geom: a fill patch folds where its normal reverses between neighbours, not where it turns past the middle's
The fold check refused a patch whose normal, anywhere on a grid, was a right
angle or more from the normal at its middle. A fill may turn its normal that
far without folding: a dome that meets a tube's wall tangentially is vertical
at its rim (90° from its top), a window round more than half a cylinder turns
past 120°. A fold is the surface turning back over itself, which reverses the
normal between neighbouring points of the grid (24 × 24, 3.75° steps on a
half cylinder); that is what is refused now, and a normal that vanishes
inside the patch. It may vanish at a corner where two sides run on straight
(a closed loop's pieces) and on a three-sided patch's pole.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-29 12:05:17 -04:00
..