Files
solidcraft/crates/engine
jyvikoandClaude Opus 5.5 7664925fbf Sketch: Project onto Surface keeps the side the projection meets first, in one curve
SMLib's parallel projection (CreateParallelProjectionCurves) gives every curve where the
projecting lines cross the face: a line projected down onto a ball came back as its top and its
bottom, each split at the pole, and the link's first wire was half the bottom. A projection onto
a surface is where those lines first hit it (owner's decision, as mainstream CAD does): a curve
is now kept only when the first hit on the body's mesh along the line through its middle is the
curve itself (within 4 chord tolerances), and the pieces that meet end to end are joined in
whatever order and direction they come, a piece run the other way exactly (its knots and
control points reversed; a line's, circle's or ellipse's parameter mirrored). The ball's top
is then one wire from x = -10 to 10.

three_d_sketch_curves now expects that exact curve: one wire, its ends at (±10, 0, √300), every
point of its exact curves on the sphere of radius 20 in y = 0 over the top, to the projection's
own tolerance (a millionth of the body's size), and sweeps_and_pipes_follow_3d_sketch_curves
pipes along the whole joined top. Both pass on the pinned SMLib (90aabff): the pieces lie 9.1e-6
off the sphere against a 4e-5 tolerance and meet at the pole within 4.7e-8 rad, since the fork's
8d95600 keeps the pole's exact tangent in StepBackFromSingularity.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-29 19:40:02 -04:00
..