An SMLib result where one shell uses an edge four or more times (a hole tangent to the outline,
touching holes, stepped cuts touching along a line) was refused as "not supported yet: a solid
touching itself along an edge". The export now reads SMLib's radial order round each edge
(EDGEUSE_NEXT_RADIAL, EDGEUSE_RADIAL_ENTRY) and the side of each face its material is on, and
gives each pair of faces across one sector its own copy of the edge: the pairs across material,
so the surface is cut apart round each wedge of material, unless one face would get two copies
(a face on both sides of the line), which SMLib's check refuses as coincident edges (tests 33,
34); then the pairs across the empty sectors, so that face keeps one edge on both sides, as
SMLib's crack edges do. The vertices at the ends stay shared: copies would give a face passing
the point twice two coincident vertices, which SMLib refuses too (test 32). Geometry unchanged;
each copy keeps its edge's tolerance and history (Order.pieces). The radial arrays are checked
as hostile input (in range, cycles on their own edge).
Tests: a hole tangent to a block's outline exports with the line copied once per wedge (each
copy joining faces on one side of it), every edge two uses, and goes back into SMLib valid at
the same volume; a blind hole tangent to a side leaves the side a crack; through SMLib both come
back as one solid with verified history and empty validity.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017itGh5fpMEousnZ91cYcVt