Files
solidcraft/crates/doc
NOWN-DEVandClaude Opus 5.5 9c2b888b40 Sheet metal: a cut or outline corner a hair from a bend line no longer breaks unfold and refold (#12224)
Three ways a flat pattern whose edges come within 50 nm of a bend zone's edge failed:

- An outline with a vertex a hair from where a bend zone ends (a collinear vertex, as a DXF
  split at its bend lines has) is split there, and the panel's loop keeps an edge that short.
  SMLib's face builder refuses it ("SMLib failed (status 1001)"), so unfold fails. Such hair
  edges are now merged into the line they run along.
- A cut-out whose edge stops a hair short of a bend line, or past it, or whose rounded corner
  ends tangent a hair beside it, leaves a sliver face along the line, which the sew cannot tell
  apart from its neighbour ("ambiguous edge contact"), so refold fails. Corners that close are
  now moved onto the bend zone's edge (an arc moves with its centre); the cut moves under 0.05 µm.
- The planar booleans close a loop within 1 nm, but hand back free-form loops whose pieces are
  up to tens of nm apart, which a following extrude or boolean refused. Gaps under 50 nm are now
  welded before a loop is extruded or combined.

A cut-out that encloses no area is skipped.

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-06 12:50:38 +00:00
..