Files
solidcraft/crates/engine
DanielandClaude Opus 5.5 155387bac1 Sketch Trim: a cut on a shape's centre ends the piece there, with no second point (#12101) (#12103)
* Sketch Trim: a cut on a shape's centre ends the piece there, with no second point

Trimming half of a center rectangle's diagonal left two points at the centre. Trim dropped the diagonal's Midpoint constraint and ended the kept half on a new point held only on the other diagonal, so the old centre was free and the new end slid along the other diagonal. Dragging a corner pulled them apart.

A cut that lands on a point held at the middle of the trimmed line or of the cutter now ends the kept piece on that point. When the trimmed line held it, the Midpoint moves to the cutter if the point is the cutter's middle too (a rectangle's diagonals bisect each other), and otherwise the point is held on the cutter as a new end would be.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Trim: weld the cut end before a parallel distance moves onto it

A distance between parallel lines that measured from the trimmed line's end moves to the kept piece's start. When that start is a cut welded to a centre point, the move named the new point, which the trim then removed along with the dimension. The weld now happens first.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Trim: test that a parallel distance moves onto the welded centre

Trimming the start half of a center rectangle's diagonal moves a distance to a parallel line onto the kept half's start, which is the centre. The test fails if the weld runs after that move: the dimension then names the cut point and is removed with it.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Trim: the centre comment names the case that reaches it

Only a line carries a Midpoint, so the comment's ellipse case could not reach this code.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Trim: a crossing line whose middle is only near the cut gets no midpoint hold

Trimming a line at its held midpoint moved that hold onto the cutter whenever the cutter's middle sat at the cut, so a crossing line that merely happened to have its middle there was tied to the point. The hold now moves only when the sketch makes the two lines diagonals of a parallelogram (each pair of opposite sides held parallel, horizontal or vertical), as a center rectangle's are; otherwise the point stays on the cutter.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Trim: ask the solver whether a cutter's middle is held at a cut midpoint

Moving a cut midpoint's hold onto the cutter only for a parallelogram of parallel, horizontal or vertical sides missed rectangles the sketch holds another way: with the bottom side held square to a side instead of horizontal, trimming a diagonal at the centre left the centre held only on the other diagonal, one degree of freedom freer than before. The hold now moves when the sketch already implies it, that is when adding it to the sketch as it was takes away no degree of freedom.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Trim: solve for the implied midpoint only when a cut lands on one

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-04 21:39:58 +00:00
..