jyvikoandClaude Opus 5.5
7d00ad78c4
The patch fill meets its neighbours to G4, so Construction::Patch now offers g0 to g4: the surface.patch command takes g3 and g4 and the Patch dialog's continuity row offers "Curvature change" and "Smooth curvature change" by itself, from the one table. The three-round corner test patches G2, G3 and G4 and reads the seams with the Continuity Analysis too: the middle of each seam (30-70 %) at the order asked; the whole seam G1, since at the corners the rounds' curvatures differ and no patch can meet both. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01DtL5Lzv2n8fyKqD61NCHSF
12 lines
1.5 KiB
JSON
12 lines
1.5 KiB
JSON
{
|
|
"description": "A corner where three rounds meet: a 40 x 40 x 30 box with its vertical edge rounded R8, then its two top edges and the arc between them over that round rounded R4 (one tangent chain). The top round rolls over the vertical one in one blend face at the corner, which meets its neighbours tangent but jumps in curvature. It is taken off (face.delete with heal false) and the hole patched from its four edges with Curvature (g2) and, beside it, with Curvature change (g3). Both meet the rounds and the top in tangent plane and curvature; the g3 patch also meets the curvature's rate of change in the middle of each seam (below 1e-4 /mm^2, against 0.27 to 0.63 for g2).",
|
|
"commands": [
|
|
{"command": "solid.box", "params": {"corner": [0, 0, 0], "length": 40, "width": 40, "height": 30, "body_name": "Plate"}},
|
|
{"command": "solid.fillet", "params": {"body": "Plate", "edges": [[40, 40, 15]], "radius": 8}},
|
|
{"command": "solid.fillet", "params": {"body": "Plate", "edges": [[40, 20, 30], [20, 40, 30]], "radius": 4}},
|
|
{"command": "face.delete", "params": {"body": "Plate", "faces": [[37.79, 36.155, 28.43]], "heal": false}},
|
|
{"command": "surface.patch", "params": {"body": "Plate", "edges": [[34.828, 34.828, 30.0], [37.657, 37.657, 26.0], [38.828, 32.0, 28.828], [32.0, 38.828, 28.828]], "continuity": "g2", "body_name": "Patch G2"}},
|
|
{"command": "surface.patch", "params": {"body": "Plate", "edges": [[34.828, 34.828, 30.0], [37.657, 37.657, 26.0], [38.828, 32.0, 28.828], [32.0, 38.828, 28.828]], "continuity": "g3", "body_name": "Patch G3"}}
|
|
]
|
|
}
|