* Fillet fit: a round counts only what lies between its edge and its arc The fit check refused a round when any other face of the body reached into the wedge between its edge and its two setback lines. A round changes only the part of that wedge between the edge and its arc: a face on the ball's side of the arc is left as it is. An outside round concentric with the inside round of a 3 mm wall (R18 over R15) was refused as too large (largest 14.21 mm) although it keeps the wall 3 mm thick. The face check now tests a round's fan of prisms from its edge to its arc (Frame::pieces, already used for blends that cross), after the wedge as a quick filter. Chamfers keep the wedge, which is what they change. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01L15TLCjpXsQdp8ovC4ZacH * Fillet fit: a curved face clears a round's thin end pieces only by a chord (#324) The fan test shrank each piece by the curved faces' tolerance; the thin pieces at the arc's ends vanished, so a hole wall 0.3 mm into a round beside it was missed and the round failed to build instead of offering the radius that fits (issue_324_tests). Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com> Co-authored-by: bherbruck <brennen.herbruck@gmail.com>