Since 09c979a4b a circle is one closed arc, so an extruded circle's wall, a hole's wall and a
cylinder's side are one face each, closed along a seam. Tests that counted truck's two halves:
- certified_annulus_side_rows_follow_radius_edits_and_clone and
certified_side_transfer_preserves_geometry_and_unsupported_taper_refuses_atomically: the
painted outer wall is 1 face (every vertex of it still at the painted radius), not 2;
- offset_surface_of_a_cylinder_and_a_box_top: the offset sleeve is 1 face (its area 2π·12·20
unchanged);
- press_pull_then_curved_face_offsets_it: a click on the hole's wall offsets its 1 face;
- pi_case_faces_per_step_at_both_heights: each standoff (a ring, Ø6 round a Ø2.5 hole) adds 4
faces, not 6: its outer and inner wall, its top, the floor inside its hole. So 23 after the
first and 35 after the pattern of four; the port openings (3 × 4), the end cut-out (4) and the
five vents (5 × 4) are planar and add what they did: 47, 51, 55, 71.
- the_round_sides_of_a_thin_ring_are_named_by_the_circle_they_run_beside: a thin ring 2 thick
about the R10 circle has two walls, `F2:wall:c1:left` (radius 9: the counter-clockwise
circle's left is inside) and `F2:wall:c1:right` (radius 11), with no numbers; each name is
found again by a point on its own wall.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>