Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 b90a5851c5 kernel: open a half sphere's loop at its pole, so its seam closes
A sphere from SMLib cut through its centre keeps one face bounded by its
rim and by its seam from the pole up to the rim, used both ways. Unwrapped
along the loop, both runs of the seam landed on one parameter line and the
loop came out one period short, so the planner took it for a face winding
round the sphere and cut it along a new line of its own. The two seam runs
stayed inside that strip as a slit of zero width, triangulated on each side
separately: open edges along the seam up to the rim (gaps up to 9.5e-3 mm
at chord 0.1), a zero-angle triangle and a non-manifold edge at the pole.

Such a loop is now unwrapped from the node after the pole round to it and
started at the node before it: the seam's uses lie a period apart on either
side of the face's parameter box, which then meshes like any sphere patch,
both uses on the seam's own nodes. It is kept as it was unless the opened
loop spans at most a period with a positive area and no longer winds.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01QWhMwdqJYQKQq8RCLSL1LT
2026-10-27 02:28:46 -04:00
..