A joint origin at a face's centre (`joint.origin {face}`, `Snap::FaceCenter`) was the face's
area centroid, holes included. A hole cut into that face, moved or suppressed therefore moved
every part held at the face's centre, though the face's outline stayed where it was: on a
200 x 100 plate with a 20 mm hole, 0.31 mm for each 20 mm the hole moves and 0.62 mm when the
hole, 40 mm off the middle, is suppressed.
On a planar face with holes the origin is now the middle of the area the face's outer boundary
encloses (`outline_centre`: the face's triangle sides that no other triangle of the face runs
back along, corners matched by place, chained into loops in the face's plane; the centroid of
the loop enclosing the most area). A named face (`NamedFace::plane`) and the planar face
nearest a point (`nearest_plane`) both use it. A face without holes, or one whose mesh gives no
clean outline, keeps its centroid as before.
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>