Files
solidcraft/crates/doc
jyvikoandClaude Opus 5.5 4ca7793a3c doc: a hole in sheet metal is a cut-out or a bore by its drill's direction
sheet_hole_cut chose by failure: a hole's drills were tried all at once and, if that was
refused, one by one; each drill was tried as a flat cut-out and, if that was refused (or
machined nothing), as a bore. Now the drill's geometry decides, one path each:

- SheetBody::drilled_panels: the panels a straight drill meets and how square it is to each
  (|panel normal · axis|); a drill into a bend is refused, as before. add_bore uses it.
- sheet_drill: square across every panel it meets is Drill::Across (sheet_primitive_cut, a
  cut-out or pocket of the flat pattern), along every one into a rim is Drill::Along
  (sheet_bore_cut, a bore), meeting no sheet is None, and anything else (square to one panel
  and along another, or at an angle) is refused with the angle message.
- The all-at-once pass (sheet_drill_cuts) passes its errors on; its None (the drills not all
  square along one axis) still puts the model back and drills them one by one.
- sheet_bore_cut passes add_bore's refusal on instead of answering None.

(not built: base in progress)

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017itGh5fpMEousnZ91cYcVt
2026-10-27 02:28:50 -04:00
..