* claim: #2424
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01SBN24y2TcqRcm2zn8Gkj27
* Sketch Offset: constrain to the ends of an offset spline (#2424)
An associated offset spline hid all of its generated fit nodes, its two
end points included, so nothing snapped to them, and a curve drawn from
one shared the node and was refused ("invalid offset output point roles").
- An open offset's end points are shown and snapped to again; its
interior fit nodes stay private.
- After every sketch edit, a curve that took an offset node gets its own
point there, coincident with the node: the offset keeps sole ownership
and the curve follows the offset when its source moves.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01SBN24y2TcqRcm2zn8Gkj27
* Scenario: lines snap to and close onto an offset spline's ends (#2424)
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01SBN24y2TcqRcm2zn8Gkj27
---------
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
leValdemar19andClaude Opus 5.5
86b2b97d6f