Files
solidcraft/crates/doc/src/format
jyvikoandClaude Opus 5.5 80e47130b9 Thread: the pipe forms in the dialog, ISO 7-1's Rp, a chamfered tip on a taper thread
The thread dialog offers the pipe threads: G (ISO 228-1), Rp (ISO 7-1), R and Rc (ISO 7-1) and
NPT (ASME B1.20.1). Their sizes are listed by designation without a pitch, one start and a hand
of right or left; a size picked for a hole the dialog sized Rc stays Rc.

Rp, ISO 7-1's parallel internal thread an R screws into, is a form of its own (`rp`): the
parallel profile (H = 0.960491 P) at ISO 7-1's gauge diameters, refused on a shaft. Its cut
meets the analytic material of its profile within 1e-5, as G does.

A taper thread takes a chamfered tip: each end's cone is measured from the major diameter the
taper has at that end. Pipe threads are not ISO metric, so they give chamfer_depth.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 13:02:32 -04:00
..
2026-10-16 06:22:21 -04:00
2026-10-17 11:55:05 -04:00
2026-10-18 18:10:44 +00:00
2026-10-20 11:41:10 -04:00
2026-10-21 08:46:14 -04:00
2026-10-21 21:13:21 -04:00
2026-10-22 17:40:01 -04:00
2026-10-23 12:09:47 -04:00
2026-10-23 17:14:35 -04:00
2026-10-24 18:53:40 -04:00