a_modelled_thread_in_a_bore_meshes_inside_its_block held each face's triangle area to within 5%
of its surface's area. At the 0.1 mm tolerance, face 18 failed that: 1.777 mm^2 of triangles
over 1.522 mm^2 of surface. Face 18 is the groove's crest band where it runs out through the
block's end, a wedge at most 0.44 mm wide. Its boundary sides are the helix edge's chords, 1.37
mm long and sagging 0.062 mm (inside the tolerance). A flat triangle on such a chord bridges the
sail between the chord and the edge instead of following it, and the band is no wider than the
sag. The excess, 0.255 mm^2, is less than the sails along the face's boundary (sum of 2/3 L sag
= 0.62 mm^2). Every triangle is within the tolerance: the chord check passes. No triangulation
of the inside changes this; the boundary nodes are the shared edge nodes.
The check now allows 5% plus the boundary's sails at the tolerance, 2/3 L tol per boundary side.
A zigzag that multiplies a face's area, which this test exists to catch, is still far outside
that. On the run-out root band the bound allows about 40% at 0.1 mm and 5% plus 4 mm^2 at
0.01 mm, against the former 6x.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>