Files
solidcraft/tools
jyvikoandClaude Opus 5.5 7bfc184e8e A modelled thread's chamfered tip (ISO 4753)
`tip: chamfer` cuts ISO 4753's chamfered end at each free end a modelled external thread
reaches, after the groove, so the last teeth taper into the cone instead of ending in a
ragged first turn: the material outside a cone `chamfer_angle` to the axis (default 45°)
reaching d_f = d - 2 `chamfer_depth` at the face's end (default the external minor diameter,
the largest the standard allows), a revolved ring cut by one boolean per end. Past the end the
ring keeps to the radii the groove's overrun already cuts. An internal thread is refused (its
entry takes the hole's countersink), as is a tip with no free end or on a cosmetic thread.

The cone is axisymmetric and cut after the screw-symmetric groove, so the volume is the stock's
chamfered section with the thread's material fraction: engine test (both ends 45°, and 30°
x 0.5 mm at a shaft's one free end above a collar) within 1e-4, ladder 06/017 (measured
2.4e-7 off).

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 02:28:53 -04:00
..