Files
solidcraft/crates/kernel/src
jyvikoandClaude Opus 5.5 7b984936a9 kernel: an emboss's arcs run on their wall's own frame, and its seam is read from the circle's angles
Two readings of the SMLib record went wrong in emboss_cylinder:

- The footprint arcs were labelled on the sketch's radial frame. The assembly gives each new
  circle edge the NURBS form on its label's quarter grid, and the wall face keeps its own form on
  its frame's grid (a cylinder's seam lies at an odd angle, build::SEAM_ANGLE). The two grids
  differ by a non-quarter turn, so the arc's form is not a straight line in the face's (u, v)
  and no exact pcurve exists: "no exact pcurve of a NURBS on a spline surface". The arcs at the
  wall's radius are now labelled on the wall face's frame (form::on_frame), so their forms lie on
  the face's grid and the pcurve is exact.
- wall_angles took the edge's interval as the circle's angles. On an SMLib record the interval
  is on the edge's NURBS form (2πr long for a whole turn), so a wall spanned some 63 rad: a
  profile across the seam was accepted, and a wall of radius 0.1 was refused as off its seam.
  It now reads Edge::curve_interval.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-29 12:15:12 -04:00
..
2026-10-28 16:13:50 -04:00
2026-10-27 02:28:53 -04:00