Files
solidcraft/crates
6fffd745fd Insert Part: the Length list opens on the default length, with no "Default" item (#8020) (#8022)
* claim: #8020

Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>

* Insert Part: the Length list opens on the default length (#8020)

The list carried an item called "Default" above the standard lengths. It
never said which length it stood for, and one of the lengths below it
always was that length, so the list offered the same length twice under
two names. Change Part Size has always listed concrete lengths.

The item is gone and the list opens on the length the part would be given
anyway. The default cannot be worked out in the dialog, because it is not
one rule: a cap screw or bolt takes the first standard length at or above
2.5 d, a set screw the first at or above d, a dowel pin the first at or
above 4 d. parts.library now reports default_length beside each size's
table values, taken from the shape the engine would build, and the dialog
selects it; the test checks that report against what an insert without a
length is actually built to, for every size of every family.

Leaving the length alone behaves as "Default" did: a new size resolves
the list again, so M6 to M12 moves the selection from 20 to 30. A length
chosen by hand stays until the size changes.

Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>

* Insert Part: the labels test skips default_length too

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5 <noreply@anthropic.com>
Co-authored-by: bherbruck <brennen.herbruck@gmail.com>
2026-10-28 17:58:03 +00:00
..