Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 69a7a85cb2 kernel: SMLib sweeps round corners and along free-form paths, lofts with holes or to a point, drafts on a foot
Through SMLib, in place of "not supported yet":
- A sweep along a path with corners: each smooth run swept on its own and
  the runs joined at each corner in a mitre (each run swept on straight past
  the corner and cut back to the plane halving it, where the next meets it
  face to face), including the corner where a closed path closes; only
  moving along the path, the runs meet on the profile. History: walls from
  their segments (found half-way along each run), caps where the path ends.
- A free-form path curve (a spline's Bézier pieces, conics) reaches the
  kernel as PathSeg::Curve, its exact piece, instead of the sketch's
  polyline of lines: SMLib sweeps along the curve itself; truck's sweeps
  flatten it as before (now the piece's own polyline within 0.01 mm, which
  turns ladder 04/004 into a pass for truck too). Patterns along a path
  flatten it and measure as before. A sweep that twists, scales or follows
  rails places its stations by length along the curve.
  (Such a controlled sweep still refuses a path with corners.)
- A loft through sections with holes: each section's outline and holes are
  one SMLib profile, the holes matched as for truck.
- A loft to a point: SMLib's pyramid (smlib_loft_to_point).
- A draft extrusion with a straight foot: the foot's prism and the drafted
  part (sloping from the foot's top to the far end the taper gives) joined
  face to face; each segment names its foot and its sloping wall.

Cases now passing on SMLib: booleans/3633, sweeps/1184, 2435, 3111, 3006,
3505, 561, 96, ladder 04/003 and 004.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017itGh5fpMEousnZ91cYcVt
2026-10-27 02:28:47 -04:00
..