Files
solidcraft/crates
CamWightandClaude Opus 5.5 672ef13eb8 Drawing sheets: no centring or trimming mark longer than the largest sheet's side (#3875) (#6410)
A border profile capped every length at 5000 mm (the largest sheet's side) but two: a
centring mark's reach inside the drawing border and a trimming mark's length. A file could
give either a huge whole number, such as 18446744073709551615. The read's number check passes
whole numbers, so the profile took it as 1.8e19 mm, and saving wrote it as a decimal the next
read refused: a drawing that saved but didn't open again. K2's fuzz test of drawing files
(#3890) found it.

Both now take the cap the margins have, `MAX_SIDE_MM`, in `validate`, so the file is refused
when it's read. Layout's own checks against the sheet are unchanged, so a 5000 mm mark still
validates and is refused only on a sheet too small for it.

Tests: the hostile-profile test refuses 5000.000001 mm and 1.8e19 mm for each mark, and takes
5000 mm on its own; 4 planted faults (each cap removed or made one short) are all caught.

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-24 19:59:28 -04:00
..