fillets/4782-fillet-two-end-verticals-past-a-full-round passes: SMLib (90aabff) refuses R10 on the 15 mm wide box's two end verticals as too large, and the refusal now names the largest radius that fits, 7.5 mm (the full round). Run on aarch64 Linux with --known-failing: every other fillets case as listed. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
10 lines
1.0 KiB
Plaintext
10 lines
1.0 KiB
Plaintext
# The fillet cases that fail today, one a line: `<case> <why it fails today>`. Sorted. The fillet
|
|
# rig gate (.github/workflows/fillet-rig.yml) fails on a case that fails and is not listed here,
|
|
# and on a listed case that passes: a fix removes its line in the same pull request.
|
|
# Baseline: develop 242bbc89f with the SMLib fixes of 2026-10-29 (integration-overnight + b78bd4a), aarch64 Linux.
|
|
1207-fillet-bar-top-edge-after-boss-arc-round-r0-5 SMLib's check refuses the round: internal coincident control points in a B-spline curve (an internal pole)
|
|
4782-fillet-bar-edge-wider-than-both-faces SMLib status 1001: a convex round past both its faces is not yet built by subtraction
|
|
5158-fillet-round-just-past-a-10mm-face SMLib status 1001: a convex round 0.01 past its face is not yet built by subtraction (10.0001-10.04 open)
|
|
9-fillet-corner-curvature-with-reduce-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
|
|
9-fillet-corner-curvature-with-taper-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
|