Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 624f6d6da7 kernel: emboss on a cylinder builds on the schema 4 record; any pick on the wall is accepted
The emboss is built from the body's record: the wall's face loses the profiles' footprints,
each profile adds planar walls and its cap on the wall's cylinder at the new radius, and SMLib
builds the body from the finished record (assemble.rs: a record taken apart and finished again
in canonical order, pcurves from the record's routine for new uses, the record's own for kept
ones). surf_of and with_same_surface read the record's analytic surfaces; the topological
offset and draft that only the old kernel used are deleted (SMLib's offset faces and draft in
offset_backend replace them).

#3782: the saved pick had to lie on the half of the wall the sketch is tangent to (its angle
inside that face's span). The wall is every exterior cylindrical face of the body (a stepped or
interrupted cylinder is refused before), so the pick is checked on the cylinder between the
endcaps. The sleeve test's far-side pick now succeeds; a pick on the bore is still refused.

(not built: base in progress)

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017itGh5fpMEousnZ91cYcVt
2026-10-27 02:28:48 -04:00
..