A box edge chamfered 2 and by two distances (3 and 1, and flipped, told apart by the centre of mass); a pocket's rim chamfered 1, by two distances, 4.9 (fits), and 5 and 5.5 (refused by the owner's rule on full-width chamfers: built at 5 today). Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
18 lines
2.4 KiB
Plaintext
18 lines
2.4 KiB
Plaintext
# The fillet cases that fail today, one a line: `<case> <why it fails today>`. Sorted. The fillet
|
|
# rig gate (.github/workflows/fillet-rig.yml) fails on a case that fails and is not listed here,
|
|
# and on a listed case that passes: a fix removes its line in the same pull request.
|
|
# Baseline: develop 242bbc89f with the SMLib fixes of 2026-10-29 (integration-overnight + b78bd4a), aarch64 Linux.
|
|
1207-fillet-bar-top-edge-after-boss-arc-round-r0-5 SMLib's check refuses the round: internal coincident control points in a B-spline curve (an internal pole)
|
|
4782-fillet-bar-edge-wider-than-both-faces SMLib status 1001: a convex round past both its faces is not yet built by subtraction
|
|
5158-fillet-round-just-past-a-10mm-face SMLib status 1001: a convex round 0.01 past its face is not yet built by subtraction (10.0001-10.04 open)
|
|
9-fillet-corner-curvature-with-reduce-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
|
|
9-fillet-corner-curvature-with-taper-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
|
|
every-block-cylinder-crease-top-edge-after-arc-round-r1 the r1 round's contact seam with the block's side face reads 60 degrees (the cylinder wall's normal) at its end on the crease (8.660, 5, 15.284): G0 where the round is built tangent
|
|
every-chamfer-pocket-rim-5-5-refused refused naming 5 mm as the largest distance: the full-width chamfer (legs as deep as the 5 mm walls) builds instead of being refused
|
|
every-chamfer-pocket-rim-5-full-depth-refused the full-width chamfer (legs as deep as the 5 mm walls) builds instead of being refused
|
|
every-hole-top-rim-chamfer-10-full-depth-refused the full-width chamfer (leg as deep as the 10 mm plate) builds instead of being refused
|
|
every-hole-top-rim-r12-past-plate-bottom SMLib status 1001: a convex round past its face on the tangent side is not yet built by subtraction
|
|
every-pocket-floor-and-rim-edges-r2 a corner patch where two rim rounds meet at each concave pocket corner (23 faces, not 19) instead of the mitre the rounds make running into each other
|
|
every-pocket-rim-edges-r2 a corner patch where two rim rounds meet at each concave pocket corner (19 faces, not 15) instead of the mitre the rounds make running into each other
|
|
every-pocket-rim-edges-r5-as-deep-as-pocket a corner patch where two rim rounds meet at each concave pocket corner (15 faces, not 11) instead of the mitre the rounds make running into each other
|