A tapered extrusion of a region with holes checks, at its two ends, that each hole's section
stays inside the outer loop's and clear of the others. Those sections were made with the
start section's rule, which refuses a line the offset swallows ("draft extrusion that starts
before its profile where the taper closes a side"). At the far end such a line is ordinary: a
short line between two concave corners whose wall closes on the way up. The letter g of
"tres long" (8 mm, joined 2 mm with a 3 degree taper) has one, and the whole text was refused
with a message about the start that does not apply.
The end check now takes the section as it is there (offset_loop's swallowed lines left out, their
neighbours meeting where they were); whether the closing wall is built stays the draft's to
say. The g builds at 3 and 15 degrees.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>