Files
solidcraft/docs
56e752c182 Toasts: a close (×) with a countdown ring instead of a Close button; a shorter 3D mouse driver label (#7971) (#8763)
* claim: #7971

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Toasts: a close (×) with a countdown ring instead of a Close button (#7971)

Every toast the user may close (the status, the 3D mouse offer and the
stand-up note) has a close (×) at its top right, handle toast:<name>:close,
in place of a Close button; it does what the button did, is a kit-drawn
button with an accessible name and hover text, reachable by Tab, and dead
behind an issue report. Toasts that go by themselves draw a thin ring
around it that shrinks over their time; pointing at the offer or the note
starts their time again, as before, so their ring is full while pointed at.

The 3D mouse offer keeps three buttons, Calibrate…, Use Direct Driver (the
detail in its tooltip) and Never show again, on one row: the corner
toasts are 400 points wide, as the row's estimated widths need 356.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Toasts: lay buttons out at their drawn widths; corner toasts 360 wide (#7971)

The toast's button rows used an estimate of each button's width that ran
about 40 points over the kit button as drawn, which wrapped the 3D mouse
offer's three buttons and left the main action short of the right edge.
Each button's drawn width is now remembered and the rows laid out with it
(the estimate stands in for the one frame before a button was first
drawn), so the main action is flush right; the corner width is the
smallest round one that fits the offer's three buttons in a row: 360.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Toasts: keep the analysis status test whole after rebasing onto main

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
Co-authored-by: bherbruck <brennen.herbruck@gmail.com>
2026-10-30 13:48:29 +00:00
..