Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 54542890d1 kernel: hold every display-plan triangle to the chord tolerance
Only the Delaunay layout checked its triangles against the surface. The
grid divides each parameter direction within the tolerance, but on a
doubly curved surface the two sags add up in a cell's middle, along its
diagonal (SMLib torus 1.16x at 0.01, truck sphere 1.23x at 0.1, truck torus
1.40x at 0.01); the patches round a pocket cut into a sphere at its pole
fan out from the cut with no check at all (4.34x at 0.1, 1.90x at 0.01).

Every curved face's finished triangulation now goes through tess::sag:
each triangle is measured at its centroid and at the middle of each side
inside the face, across the surface (along the normal at the point of the
same parameters, which near a pole need not be the nearest), and the side
that leaves the surface most is split, both triangles on it together, so
the face stays conforming. Boundary sides are never split: they carry the
edges' own nodes, shared with the neighbouring face. At a pole the free
parameter of a midpoint comes from the other corners.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01QWhMwdqJYQKQq8RCLSL1LT
2026-10-27 02:28:46 -04:00
..