Files
solidcraft/crates/kernel
rlartotandClaude Opus 5.5 c64a611818 Boolean: fail an unverifiable intersection instead of keeping what it should trim (#3244) (#3344)
* claim: #3244

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Fail an unverifiable intersection instead of keeping what it should trim (#3244)

When every route of the general boolean fails, it falls back on the sampled answer
(one body whole, or nothing) with a "not verified ... that part is ignored" warning,
even when the bodies' facets cross well past their faceting error. For an
intersection that keeps exactly the material it was asked to trim: teeth standing
0.27 mm out of a trimming cylinder came back untrimmed, and `solidcraft-cli run`
exited 0 with a part 16.918 mm in radius.

An intersection whose sampled answer is contradicted by facets crossing by more than
twice the depth the warning reports (6 x the check mesh tolerance, three times the
faceting error of two meshes) now fails, and the model is kept. Cuts and unions keep
the fallback: shelling a body in two pieces relies on it (a cavity tool grazing the
other piece), with the same depth and ignored volume as this case.

Fixes #3244

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Leave an empty unverified intersection as it was (#3244)

Only a doubted intersection that keeps one body whole is refused. An empty
one ("the bodies are apart") stays a result reported unverified: the clearance
and interference checks rely on it, and main's new
a_pin_through_a_d_bore_of_its_size_still_overlaps_the_flat (#2714) expects it.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-20 12:37:43 +00:00
..