Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 4faee7dd80 Fill: the general fill takes a loop of one or two edges in exact pieces of their curves
The iso fill needs three sides or more, so a loop of one closed edge (a tube's
end) or two was refused as "a loop of 1 edges". Such a loop's edges are now
taken in equal pieces of their own parameters (one edge in four, two in two;
a break that falls on one of the curve's knots, a conic's quarter points, is
that knot exactly), each piece the edge's own curve segmented exactly; the
patch's edges are those pieces, their ends new vertices shared by the pieces
either side. A piece of an edge the loop runs against has its parameter
reflected about the edge's interval, as a whole edge's is.

The tube end is still refused: one four-sided patch on four quarters of a
circle has corners where its sides run on straight (180°), and the G1 dome
folds there.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-29 12:05:17 -04:00
..