* Slightly fix the extend tool
* Extend: add the line the preview draws, and stop an arc on another curve
sketch.extend reported "nothing to extend to" whenever nothing stood in the
line's way, even though the viewport previewed a line past its end; with
nothing in the way the extension now runs as far as the preview shows, on the
same measurement, so the click adds what was drawn.
An arc extension that ran into another circle or arc refused the target when
its crossing already belonged to another curve's end (a shared crossing point
of two circles): that point is now joined instead, so the extension closes onto
the geometry that is there.
---------
Co-authored-by: SolidCraft Dev <dev@solidcraft.local>
Co-authored-by: n0tfr3shm1lk <n0tfr3shm1lk@ukr.net>