Files
solidcraft/crates/engine
44bd29acc3 Hole: refuse a position that isn't on the face (#5024) (#5029)
* claim: #5024

* Hole: refuse a position that isn't on a face (#5024)

`solid.hole` took any `position` and drilled from the nearest face, so a
point 1 mm past a box's side was accepted and cut a hole across the edge.

A position given as a point (numbers or length expressions) must now lie on
a face of a body, within the same tolerance the plastic features use for
their placement (the check is shared with them). Holes at sketch points are
unchanged.

* Hole: a position over the mouth of a bore or opening of a planar face is on that face (#5024)

A counterbore is centred on an existing bore, in the plane of the face round it.

Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>

---------

Co-authored-by: bherbruck <brennen.herbruck@gmail.com>
Co-authored-by: Claude Sonnet 5.5 <noreply@anthropic.com>
2026-10-25 17:42:15 +00:00
..