Files
solidcraft/crates/engine
Kai Evans 41a938e731 Sketch: a fillet stays the arc of its corner when the corner mirrors or a line is dragged through it (#5677)
A line tangent to an arc at the arc's end had no sense: the tangency held
with the line on either side of its touch point, so pinning a line's far
end across the corner left the line cutting back through its fillet, and
when the solver found the mirrored corner the arc kept its stored
direction and became its three-quarter complement, inside out.

The solver now keeps each fillet an arc of its corner. A line tangent at an
arc's end keeps its sense there (it leaves the arc as it did) and the arc
its side of its chord, compared with the positions before an interactive
move or the stored ones. A corner that mirrored gets its arc on the
mirrored side: its ends swapped where the solve ran the arc round the
other way with the lines following, or the arc reflected across the line
that stayed and solved again where a line cut back through. A solve that
would loop the arc the other way round, or fold a line onto it, is refused
as a fold is. A drag's cursor-following steps keep the fillets too, so a
line dragged through its own fillet stops at the arc.
2026-10-26 10:42:41 +00:00
..