* Sketch: Remove Spline Point takes one fit point out of a spline (#10783)
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
* Sketch: Remove Spline Point takes one point out of a spline (#10783)
sketch.spline.remove_point takes one fit or control point out of a
spline. The spline keeps its id and runs through its other points, which
stay where they are. The point goes with the constraints on it, unless
another curve uses it. A closed spline's closing point, an end joined to
other geometry, the last 2 points (3 when closed), and projected, offset
or patterned splines are refused with a message.
The right-click menu of a spline point, picked alone, offers it beside
Reverse Spline Direction.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
---------
Co-authored-by: Claude <noreply@anthropic.com>