Files
solidcraft/crates/engine
semmelrindeandClaude Opus 5.5 7b24a1dc1e Sketch corners: a round that would use up an arc, or where the curves meet smoothly, is refused (#8813)
* Sketch corners: a round that would use up a whole arc is refused

A quarter arc of radius 5 running into a line along it, rounded with
radius 5, put the round's tangent point at the arc's other end and left
an arc of no length. round_corner now skips a round whose tangent point
falls on either curve's other end; with none left it says that radius
does not fit, as for two lines (found by a local trim fuzzer).

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch corners: a round where the curves meet smoothly is refused

A line running on from an arc's end along its tangent (off only by rounding)
has no corner, but the round's tangent points landed within 1e-7 mm of it and
the round came out as an arc of no length (found by a local trim fuzzer). The
corner test's line met its arc this way too and was checking that output; it
now meets the arc at a corner.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-30 06:23:17 +00:00
..