Files
solidcraft/crates/engine
yhamil04andClaude Opus 5.5 3afcd69a5c Joints: a loop whose axes are a hair out of parallel still moves (#6211) (#6602)
* claim: #6211

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Joints: a loop whose axes are a hair out of parallel still moves (#6211)

Holes picked on parts are rarely exactly in line. A closed loop through
axes a few hundredths of a microradian apart (a lever, link and a rod on
a cylindrical axle) can't close exactly: it closes to nanometres, and the
gap grows as it turns. The loop solver wanted 1e-7 mm, so it threw such a
closure away (the loop stayed open, its parts at 0 dof) or stopped a drive
or drag after a fraction of a degree.

The conflict check is now 1e-4 mm / 1e-6 rad (it was below what its
message can show), and joint.drive / motion and joint.reach close the
loop at each step as at the start: to the tight tolerance where they get
there, otherwise within the conflict check.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-26 11:10:45 +00:00
..