The owner's ruling of 2026-10-30 (d7): a chamfer that reaches or runs
past a rim builds, everywhere. The earlier rule refused a full-width
chamfer, naming the largest size that fits. SolidCraft has no such
refusal of its own (a blend's TooLarge is SMLib's SMLIB_ERR_NO_ROOM,
and the doc layer only names the largest fit), and SMLib already builds
these, so only the expectations change, each from a closed form or an
exact quadrature:
- chamfer_wider_than_sloped_basin_rim_is_refused's full widths become
chamfer_as_wide_as_sloped_basin_rim_builds: the whole triangle,
d drop / 2 (60 - drop / 3), drop = 20 d / sqrt((20 - margin)^2 + 400)
(shoelace over the section, its length 30 + z between the sloped end
walls): 21.662379 (1 on 1 mm), 5.359321 (0.5 on 0.5 mm). The basin and
the removal move into sloped_basin and sloped_basin_rim_chamfer_removed.
- fillets/1080-chamfer-sloped-basin-{1,0-5}-mm-rim-as-wide-as-the-rim:
V = 144511.670954, 144261.307346.
- fillets/every-chamfer-pocket-rim-5-full-depth: 50 d^2 + (4/3) d^3 at
d = 5, V = 19583.333333, 11 faces (the walls used up).
- fillets/every-hole-top-rim-chamfer-10-full-depth: the triangle 10^2/2
revolved at rho = 5 + 10/3 (Pappus), V = 16000 - 3250 pi / 3 =
12596.607959, 7 faces.
- fillets/1113-chamfer-arc-top-edge-full-wall-height: the 9.5 case's
Int rho asin(21/rho) h(rho) drho at s = 10, by Gauss-Legendre in
u = asin(21/rho), 1303.400331, V = 8287.993768.
Each drops "-refused" from its id and its KNOWN_FAILING line goes: all
five pass on SMLib 985faaee.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>