Files
solidcraft/crates/engine
jyvikoandClaude Opus 5.5 361b35afee Thread: a shoulder thinner than the overrun's reach is still a shoulder
The free-end test looked for material 1 to 1.5 pitches past the face's end, beyond the first
pitch so that a chamfer the groove runs out through counts as free. A plate thinner than that
(a boss on a 1 mm plate under M10) had none there, so its top was taken for a free end and
the groove's one-pitch overrun cut into the plate (15 mm³ of a 1 mm plate).

An end is now closed when, over the overrun's whole reach, material lies outside the face's
cylinder (inside it, for a hole) at the radii the groove cuts beyond the face: a shoulder,
plate, head or blind bottom, however thin, steps out past the face, while a chamfer, neck,
countersink or counterbore steps the other way. The band test beyond the first pitch stays
for a cylinder that goes on past a split.

The regression test builds the boss as the app does (a rounded plate, a circle sketched on its
top face, extruded with Join) on 6 and 1 mm plates.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-27 13:02:32 -04:00
..