The owner's blend-overflow ruling of 2026-10-30: a chamfer whose leg runs
off the face beside its edge over another face is refused as too large,
naming the largest size that fits (a 2 mm chamfer on the basin's 1 mm rim
would lower the slab's front face from 30 to 29.382); a full-width chamfer
stays refused. Two tests wanted those chamfers built and cut from the slab:
- chamfer_wider_than_sloped_basin_rim_is_cut_and_a_full_width_one_refused
becomes chamfer_wider_than_sloped_basin_rim_is_refused_naming_the_largest:
(margin, d) = (1, 2), (1, 3), (0.5, 4) and the full widths (0.5, 0.5),
(1, 1) are TooLarge, the body unchanged, and the message names a largest
size just below the rim's width: the full width is refused, so the fit
search (three significant digits of the size asked, step
10^(floor(log10 d) - 3)) ends one step below it, in
[margin - step, margin). The removal formula for the cut chamfer
(basin_rim_chamfer_removed) has no use left and goes.
- equal_slope_rim_loops_stay_inside_the_material: the 2 mm chamfer of the
1 mm rim's loop is refused the same way (largest in [0.999, 1)); the R4
round (tangent side, builds) and the 0.5 blends stay.
The half-width chamfer on each rim, which only had to take something off,
now takes its exact volume. As in chamfer_sloped_basin_rim: the triangle
with legs d on the top and d down the wall towards (20, 10) (run
20 - margin over the 20 drop) has area d * drop / 2 with
drop = 20 d / sqrt((20 - margin)^2 + 400), and the chamfer's length at
depth h is 60 - h between the end walls x = 20 + (30 - z) / 2 (planar:
x depends on z only), so it removes d * drop / 2 * (60 - drop / 3);
graded at 1e-8 as that test is.
Today SMLib refuses the chamfers as too large, but the message does not
name the largest that fits yet ("the chamfer is larger than the faces
beside its edges allow"), the SolidCraft change issue_1080's R30 test
waits for too.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>