Files
solidcraft/crates/kernel
jyvikoandClaude Opus 5.5 27e996c44d brep: splines closed on themselves are periodic for pcurves and tessellation
A spline surface whose first and last control rows coincide in a direction
(points and weights, knots clamped there) closes on itself, but the display
evaluator's domain gave NURBS no period. The pcurve routine therefore never
moved a seam's second use by a period: SMLib's fillet round a hole's rim (a
rational spline closed in u) got both seam pcurves on u = 0, its outer loop
enclosed no (u, v) area, the decoded face tessellated to nothing and the body
measured 6839.73 mm3 against SMLib's 6989.00.

tess::uv::closed detects the closure from the record, within 1e-9 of the
control net's extent; the domain then has period = the active knot interval's
width, and the evaluator wraps a parameter outside that interval back inside
it, so pcurves, projection, sizing and the display plan all treat the direction
as periodic. The record stays as it is. The display plan hands both evaluators
wrapped parameters (the GPU does not wrap).

Tests: a rational torus band, a NURBS cylinder and a NURBS dome with a pole,
each bounded by a seam used twice, get seam pcurves one period apart; a record
of the band passes check_geometry and its seam uses on one line are refused;
SMLib's hole-rim fillet decodes with every face meshed and SMLib's volume
within 1e-3.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01QWhMwdqJYQKQq8RCLSL1LT
2026-10-27 02:28:44 -04:00
..